FOR METAL BUILDING ROOFING
RC-7, RC-8
Furnish and installed prefabricated roof curbs as manufactured by Roof Products & Systems Corporation, Bensenville, IL. at all roof openings as specified on drawings.
Curbs shall be Box Section Design, 18 gauge galvalume steel (14 gauge for curbs supporting HVAC units or as required) with continuous welded seams (separate 14 ga. water deflector plate on RC-8 only), integral water deflecting cricket and shall be insulated with 1 1/2", 3lb. density rigid fiberglass board.
Roof Curbs shall be internally reinforced on any side longer than 3' -0" and shall have factory internal base plate. Height to be 8" high or as detailed. Roof Curbs shall be level at top with pitch built-in.
| MODEL SELECTION |
| Series- RC-7 On Panel Rib Pre-engineered Metal Building decks use RPS Model RC-7 surface mount style. |
| Series- RC-8 On Standing Seam Pre-engineered Metal Building decks use RPS Model RC-8 surface mount style. |
| OPTIONAL FEATURES | |
| 1. | ADDITIONAL HEIGHT |
| 2. | ROOF PITCH REQUIREMENTS |
| 3. | BURGLAR BARS |
| 4. | WOOD NAILER |
| 5. | ALUMINUM CONSTRUCTION |
| 6. | NEOPRENE GASKET |
| 7. | HEAVIER GAUGES |
| 8. | LINERS |
| 9. | SOLID PLATFORM TOPS |
| 10. | ISOLATION RAILS |
| 11. | DAMPER TRAYS |
| 12. | CONSULT FACTORY FOR OPTIONS NOT LISTED |
All information is subject to
change without notice. Dimensions and specifications shown are within
manufacturing tolerances.
© Copyright Commercial Products Group of Hart & Cooley, Inc.,
November
2007. All Rights Reserved.
