FOR ALL ROOF SYSTEMS
The RPS DUCT MOUNTING PEDESTAL is the ultimate solution to mounting duct runs on flat or pitched roofs. The RPS Equipment Rail assures the proper mounting and flashing base, while the duct and attachment assembly allows for duct movement from expansion and contraction and has 12" vertical and horizontal adjustments to mount ducts level and straight. The RPS DUCT MOUNTING PEDESTAL has a full line of features that allows for single to double mounting with a minimum of effort and a maximum of speed.
• RPS
EQUIPMENT RAIL- for a solid base and sure footing
• CONTINUOUS
THREADED GALVANIZED RODS- allows height adjustment for the full length
of the rods
•
GALVANIZED STEEL
SLIDE CHANNEL- allows lateral adjustment for the full length of the
channel
• ALL SIZES-
accommodates all duct sizes up to 10'- 0"
•
OPTIONAL FEATURES- longer Equipment Rails and slide channels, offers
multi-duct mounting on a single Equipment Rail
SPECIFICATION
Furnish and install RPS DUCT MOUNTING PEDESTALS as manufactured by Roof Products & Systems Corporation, Bensenville, IL, at all locations shown on drawings.
Duct Mounting Pedestals shall each include an RPS Equipment Rail 12" longer than the duct width for single duct support, with a single galvanized steel slide channel equal in length to the equipment rail attached to galvanized steel "U"-shaped mounting brackets secured to the side of the equipment rail with lag bolts. The duct mounting slide assembly shall be sized to suit the duct supported and fabricated of galvanized steel and shall have galvanized 18" long continuous threaded rods to allow 12" vertical adjustment, and lateral adjust spacer bracket for 12" horizontal adjustment.
All information is subject to
change without notice. Dimensions and specifications shown are within
manufacturing tolerances.
© Copyright Commercial Products Group of Hart & Cooley, Inc.,
November
2007. All Rights Reserved.
